Silk’n LED FACE MASK 100 Manual De Usuario página 12

5. When charging is done, unplug the USB wall adapter from the
mains socket and disconnect the USB cable from the charging
port of the remote control.
6 Assembly
1. Open the hook-and-loop fasteners on the elastic straps
2. Guide the small elastic
openings and the large elastic straps
openings of the face mask
3. Close the hook-and-loop fasteners to secure the elastic straps
on the face mask (see step 2 in Fig. B).
7 Operation
WARNING! RISK OF INJURY!
• Do not use the product for more than
15 minutes per treatment.
7.1 Carrying out the treatment
1. Fully charge the product and properly attach the elastic
straps /
3 4
2. Thoroughly clean and dry your face and hands. Make sure they
are free from any make-up or dirt.
3. Sit or lie down and place the face mask
4. Use the hook-and-loop fasteners on the ends of the elastic
straps to fit the face mask comfortably on your face.
The small elastic straps
head and the large elastic straps
back of your head (see Fig. C).
5. Connect the plug
the remote control
6. Press and hold the operation button ( )
product.
By default, the product goes into Manual mode with the M1
(red) therapy selected after switching on.
7. If desired, press the mode button
between the Auto mode and Manual mode.
The corresponding mode indicator light (
according to your selection.
straps through the small top
4
1
(see chapter "Charging" and "Assembly").
should be closed at the top of your
4
of the face mask into the connector
2
.
14
through the large side
3
(see step 1 in Fig. B).
over your face.
1
should be closed at the
3
to switch on the
13
repeatedly to select
10
or
9
/ .
3 4
of
7
) turns on
12
12
EN