Publicidad
Idiomas disponibles
Idiomas disponibles
Contents
Chapter
General safety precautions for power tools
•
Specific safety precautions for Finishing sanders
•
Intended use
•
Tool description
•
Technical specifications
•
Operation
•
Maintenance and care
•
Spare parts, disused power tools and environmental protection
•
Warranty
•
General safety precautions
Read and observe the enclosed general safety precautions and this
operating manual before using power tools.
Safety precautions specific to Finishing sanders
•
Keep children and other persons away from your working area.
•
Use screw clamps or similar clamping tools for holding the work pieces in place. This
provides a much more secure grip than is possible with your hands.
•
Install an exhaust unit or a dust catching device.
•
Keep the vent holes in the sanding disc clean.
•
Before beginning work make sure there are no nails, screws or similar metal objects in the
work piece, as they can tear the sanding paper and damage the sanding pad.
•
Outlets in outdoor areas must be fitted with residual current circuit breakers.
•
The finishing sanders should only be connected to single-phase alternating current, and
only of the voltage indicated on the type plate. Since there is a double layer of insulation, it
is also possible to connect to outlets without protective contact.
•
Make sure the finishing sander is switched off before connecting it to the mains.
•
Do not put the finishing sander down until the sanding plate has come to a complete stop.
•
Be sure to disconnect the plug from the mains when inserting or changing the sanding
paper, or while performing any other maintenance work.
Finishing sander
Item No. 12555-SS135
Instruction Manual
Wear protective goggles and a dust mask for all dust-generating
work.
GB - 13
Page
13
13
14
14
15
15
16
16
17
Publicidad
