Publicidad
Idiomas disponibles
Idiomas disponibles
Connection/Installation
Ñ
Connecting wires to terminals
Connect to the vehicle's
parking brake detection switch
harness.
PRK SW
Ignition key switch
Car fuse box
Battery
Pink (Speed Pulse Input) (2 m)
S SENS
Connect to the vehicle's speed pulse harness.
Do not cut the "S SENS" tag or failure may result.
Purple/White
(Reverse sensor wire) (2 m)
REVERSE
Connect to vehicle's reverse lamp harness when
using the optional rear view camera.
26
Fuse (15A)
Accessory 1
Light Green
(Parking sensor wire)
(2 m)
For best safety, be sure to
connect the parking sensor.
Red
(Ignition wire)
Yellow
(Battery wire)
Black
(Ground wire) ¤
(To car chassis)
Other cable : Not used.
Speaker impedance: 4-8 Ω
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
If no connections are made, do not let
the cable come out from the tab.
Blue/White
(Power control wire)
When using the optional power amplifier,
connect to its power control terminal. (Max.
200mA, 12V)
Light Blue/Yellow
(Steering remote control wire)
REMOTE CONT
To steering remote
To use the steering wheel remote control
feature, you need an exclusive remote
adapter (not supplied) matched to your car.
Orange/White
(Dimmer control wire)
To car light control switch
Blue
(Antenna control wire)
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for
the booster amplifier of the film-type antenna.
(Max. 300mA, 12V)
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
P. CONT
STEERING WHEEL
REMOTE INPUT
ILLUMI
ANT CONT
Publicidad
