Publicidad
Idiomas disponibles
Idiomas disponibles
To prepare the scanner, follow these steps:
• Make sure the Lens Window at the base of the scanner is clean by wiping it with a moist, lint-free
cloth or lens tissue.
• Slide the Scanner Tip onto the scanner as shown below.
Starting scanning
To start scanning, place the Scanner Tip on the surface of the tooth to stabilize the scanner and press
the Scan button. Wait until a 3D model appears on the 3D model display screen, and then slowly move
it along the arch at 0-5mm from the teeth.
Scanning approach
The recommended scanning method is to start with a molar, since it has greater details for easier
identification. Change the scanning angle to less than 60 degrees during scanning to allow the
surfaces to overlap, if the overlap is too small, the alignment may be lost.
Scanning protocol
The recommended scanning protocol consisting of 3 sweeps: occlusal, lingual and buccal to ensure
good data coverage of all surfaces.
It is recommended to start the first sweep from the occlusal surface, and you should start with the first
molar.
The second sweep can scan both the lingual and buccal sides, and the third scan covers the opposite
side of the second sweep.
NeoScan™ 2000 Installation and operation manual // Getting started
1 5
Publicidad
