LaserLiner AutoLine-Laser 3D Manual Del Usuario página 10

2
Horizontal and vertical levelling
Release the transport restraint, set the ON/OFF switch to „ON".
The horizontal laser line appears. The laser lines can be switched
on individually with the selection button.
LASER
The transport restraint must be released for horizontal and vertical
!
levelling. The laser lines flash and a signal sounds as soon as the
device is outside the automatic levelling range of 2,5°. Position
the device such that it is within the levelling range.
3
Hand receiver mode
Optional: Working with the laser receiver RX
Use an RX laser receiver (optional) to carry out
levelling at great distances or when the laser
lines are no longer visible. To work with a laser
receiver, switch the line laser to hand-held
receiver mode by keeping button 6 (hand-
held receiver mode on / off) pressed. The laser
lines will now pulsate with high frequency,
making the laser lines darker. The laser receiver
can detect these pulsating laser lines.
!
Observe the laser receiver's operating instructions for line lasers.
10
GB
LASER LASER LASER