LaserLiner AutoLine-Laser 3D Manual Del Usuario página 8

Read the operating instructions and the enclosed brochure „Guarantee
!
and additional notices" completely. Follow the instructions they
contain. Safely keep these documents for future reference.
Three-dimensional laser with a horizontal and two vertical
360° laser circles and slope function for aligning tiles, wall
studding, windows, doors etc.
General safety instructions
Caution: Do not look directly into the beam. Lasers must be kept out of reach
of children. Never intentionally aim the device at people. This is a quality laser
measuring device and is 100% factory adjusted within the stated tolerance.
For reasons of product liability, we must also draw your attention to the
following: Regularly check the calibration before use, after transport and
after extended periods of storage. We also wish to point out that absolute
calibration is only possible in a specialist workshop. Calibration by yourself
is only approximate and the accuracy of the calibration will depend on the
care with which you proceed.
!
Always turn off all lasers and latch the pendulum in place before
transporting, ON/OFF switch in its „OFF" position!
08
GB
Laser radiation!
Do not stare into the beam
or observe it directly with
optical instruments.
Class 2M laser
< 5 mW · 640 nm
EN 60825-1:2007-10