LaserLiner AutoLine-Laser 3D Manual Del Usuario página 11

Due to the special optics required to generate a continuous 360° laser
!
line, the underlying technology may cause differences in brightness in
different areas of the line. This may lead to different ranges in hand
receiver mode.
4
Slope mode
Do not release the
transportation safety
device. Slide the ON/
OFF switch into the
centre position and
select the laser using
the selection button.
Sloping planes and tilts
can now be measured. In this mode, the laser lines no longer align auto-
matically. This is signalised by the laser lines flashing. In addition, the
LED light (7) remains red.
Technical data
Self-levelling range
Accuracy
Operating range (depending on room illumination)
Working range with hand receiver (depends on how
the technology affects the difference in brightness)
Laser wavelength
Laser class / line laser output power
Power supply
Operating time
with 3 laser levels
with 2 laser levels
with 1 laser level
Operating temperature
Storage temperature
Dimensions (W x H x D)
Weight (incl. batteries)
Subject to technical changes without notice. 04.2014
LASER LASER
AutoLine-Laser 3D
LASER
± 2,5°
± 0,2 mm / m
20 m
50 m
640 nm
2M / < 5 mW
4 x 1.5V alkaline batteries
(type AA, LR6)
approx. 6 hours
approx. 10 hours
approx. 25 hours
0°C ... +50°C
-10°C ... +70°C
85 x 130 x 160 mm
820 g
LASER
11
GB