Sigma EF-500 DG ST PA-PTTL Instrucciones página 6

Thank you very much for purchasing the Sigma EF-500 ST PA Electronic Flash. This product is
specifically developed for the PENTAX autofocus SLR cameras. Depending on the camera model,
functions and operation may vary. Please read this instruction booklet carefully. To add to your
enjoyment of photography, the flash has a variety of features. To make the most of all these
features, and to get the maximum performance and enjoyment from your flash, please read this
instruction booklet, together with your camera's instruction manual, before using the flash, and also
keep it handy for your future reference.
pRECAUTIONS iR SVtOot denotes the important points, where warning and caution are required.
\)
Symbol contains information regarding the actions that must be avoided.
A Warning !!
Using the product disregarding
this warnlng sign might cause serious injury or other dangerous
This flash coatdins high voltage circuits. To avoid electric shock or burns, do not attempt to
disassemble the flash. lf the outside shell of the unit is broken or cracked, do not touch the
m e c h a n i s m i n s i d e .
Do not fire the flash close to eyes. Otherwise the bright light could damage the eyes. Keep at
l e a s t 1 m / 3 f e e t d i s t a n c e b e t w e e n f a c e a n d t h e f l a s h u n i t , w h e n t a k i n g a p i c t u r e w i t h f l a s h .
Do not touch the synchro terminal of your camera when the flash is attached to hot shoe.
High voltage circuitry could cause electric shock.
Never use your camera in an environment where flammable, burnable, gas, liquids or
chemicals, etc, exist. Otherwise, it might cause fire or explosion.
s
s
S
s
s
A
S
A
s
S
A
I
Caution!!
[-sing tn" product disregarding this caution sign might cause injury or damage.
Do not use this flash unit on any camera other than the PENTAX AF cameras; otherwise the
flash may damage the circuitry of these cameras.
This flash unit is not waterproof. When using the flash and camera in the rain or snow or near
water, keep it from getting wet. lt is ofien impractical to repair internal electrical components
damaged by water.
Never subject the flash and camera to shock, dust, high temperature or humidity. These
factors might cause fire or malfunctioning of your equipment.
When the flash is subjected to sudden temperature change, as when the flash unit is brought
from a cold exterior to warm interiot condensation might form inside. In such a case, place
your equipment in a sealed plastic bag before such a change, and do not use the flash unit,
until it reaches room temperature.
Do not store your flash in a drawer or cupboard etc., containing naphthalene, camphor or
other insecticides. These chemicals will have negative effects on the flash unit.
Do not use a thinner, Benzene or other cleaning agents to remove dirt or finger prints from
the component. Clean with a soft, moistened cloth.
For extended storage, choose a cool dry place, preferably with good ventilation. lt is
recommended that the flash be charged and fired several times a month, to maintain proper
capacitor fu nctioning.
DESCRIPTION OF THE PARTS (fig.1)
l.Flash Head 2.Built-in Wide Panel 3.AF Auxiliary Light
4.Bounce Angle; Up and Down
5.Bounce Angle; Right and Left
6.Bounce Lock and Release Button; Up and Down T.Swivel {'-
Lock and Release Button; Right and Left
8. flash coverage angle indicator 9.Battery Cover 'r{
10.Shoe Ring 1 1 .Shoe 12.TEST Button 13.Ready Light 14.Power Switch