Disposal Of The Machine And Its Parts; Disposal Of Pneumatic Springs; Spare Parts- General Warnings; From The Manufacturer - Orved CUISSON SV-31 Manual De Uso

EN
MAINTENANCE
PROBLEM
Date and numbering are
illegible
Poor sealing.
Gas quantity in
insufficient.
Lid opens during GAS
cycle.
Vacuum not created in
containers.
8.

DISPOSAL OF THE MACHINE AND ITS PARTS

For disposing of the VACUUM PACKAGING MACHINE or its components, do not dump these in city waste bins: scrapped
appliances are not useless waste!
The machine does not contain components that are hazardous for humans or the environment; it is made of materials that can be recycled completely
or disposed of normally.
For disposal operations, contact specialist, authorized Companies. Before starting dismantling operations, make sure
there is enough clearance around the machine to carry out the operations easily.
In any case, make sure, every part of the machine is disposed off in accordance with the legislation applicable in the country of use.
8.1 DISPOSING PNEUMATIC SPRINGS
DANGER! Danger of serious injury: the pneumatic springs are loaded at about 180 bar, therefore they must not be cut or
damaged as they can burst throwing off splinters.
The disposal of these parts must be done exclusively by qualified personnel.
9. SPARE PARTS: GENERAL WARNINGS
For ordering spare parts, always indicate the following data:
• MACHINE SERIAL NUMBER (see CE plate on the back of the machine)
EN
• SPARE PART CODE (see Table)
10. THE MANUFACTURER
Thank you for your trust.
The manufacturer reserves the right to make technical and/or aesthetic modifications to our products at any moment, without any prior notice.
Operation and maintenance manual / Ed. 11 - 2008
POSSIBLE CAUSES
Timer fuse cut out.
Insufficient printing time.
Dirty contact.
Sealing bar dirty.
Sealing time insufficient
for bag basic weight.
Teflon cover worn.
Red silicone worn.
Gas flushing
bags
insufficient.
Gas cylinder pressure
insufficient.
Gas nozzle not inserted in
bag mouth.
Cylinder valve or pressure
reducer closed.
Gas percentage too high.
Cover not placed correctly.
CUISSON SV-31 • SV-41
Replace the timer fuse. (PFT - pag. 52)
Increase the printing time using the PROG and DAT keys.
Clean the contacts and the guide pins (SEE FIG. PAG. 49).
Clean sealing bar.
Increase sealing time using
Change Teflon cover.
Change red silicone.
time Increase gas percentage
Adjust pressure on cylinder reducer to 1 bar.
Reposition bag by inserting gas nozzle in the bag opening.
Open cylinder valves and adjust pressure reducer to 1.0 bar.
Reduce gas percentage
Reposition then create vacuum by pressing slightly on the lid.
54
SOLUTION
REV. 01 - Cod.: 1500288