Robur 8134 Manual De Uso E Instrucciones página 11

OPERATION MANUAL AND INSTRUCTIONS
DESCRIPTION OF THE CARRIAGE:
1. Active poles
2. Operating lever
3. Connecting grille
4. Locking system
5. Label
6. Rotor shaft
INSTALLATION
When the device is to be used for the first time: fit the lever to the rotor shaft by inserting lever 2 in the hole of rotor shaft 6 and
tightening the locking screws.
Before starting the installation, read the general warning notices. In addition:
• Check the WLL of the accessory to ensure that it has sufficient load-bearing capacity (See table "A").
• Check to ensure that there is no protective film, dirt, grease, oil or similar substances between the poles of the magnet
and the load.
The accessory should only be connected to the lifting sling after all the following preliminary checks have been carried out:
• Before starting any task, check for visible defects and faults, such as deformation, cracks, wear and tear and signs
of corrosion on the carriage, drawbar eye, the unit connected and the load-bearing structure.
• Remove any dirt from the base of the poles.
8134 WEB.indd 11 8134 WEB.indd 11
Fig. 2
Rotor active
Fig. 4
1
Rotor deactivated
Fig. 5
EN
Fig. 3
15/12/22 15:59 15/12/22 15:59
11