Publicidad
Idiomas disponibles
Idiomas disponibles
REMOTE CONTROLLER
Buttons and their functions
1-
MODE: Once pressing, running mode will be selected in
the following sequence:
Note:
No heating mode for cool only type unit.
2-
FAN SPEED: Fan speed will be selected in following
sequence once pressing this button:
3-
Adjust
: Decrease the set temp. Keeping pressing will
decrease the temp with 1 per 0.5s.
4-
Adjust
: Increase the set temp. Keeping pressing will
increase the temp with 1 per 0.5s.
5-
ON/OFF: For turning on or turning off the air conditioner.
6-
AIR DIRECTION: Activate swing function of air deflector.
Oncepressing, air deflector will turn 6. For normal opera-
tion and better cooling and heating effect, deflector will
not turn to thedegree which is the state of deflector when
the unit is turned off. (Only available when remote contro-
ller is used with corresponding unit).
7-
SWING HORIZ.:Activate or turn off horizontal swing func-
tion. (Only available when remote controller is used with
corresponding unit.)
8-
SWING VERT.: Activate or turn off vertical swing function.
(Only available when remote controller is used with corres-
ponding unit).
9-
CLOCK: Display the current time. (12:00 is displayed when
resetting or electrifying for the first time.) Press CLOCK for
5s, icon indicating hour will flash with 0.5s. Press it again,
icon indicating minute will flash with 0.5s.
used to adjust the figure. Setting or modification is effec-
tive only by pressing OK button to make confirmation.
10-
TIME ON: For time ON setting. Once pressing this button,
the time will increase by 0.5 hour. When the set time exce-
eds 10 hours, pressing the button will increase the time by
1 hour. Adjusting the figure to 0.00 will cancel time ON set-
ting.
11-
TIME OFF: For time OFF setting. Once pressing this but-
ton, the time will increase by 0.5 hour. When the set time
exceeds 10 hours, pressing the button will increase the
time by 1 hour. Adjust the figure to 0.00 will cancel time
ON setting.
12-
RESET (inner located): Press this button with a needle of
1mm to cancel the current setting and reset remote con-
troller.
13-
LOCK (inner located): Press this button with a needle of
1mm to lock or unlock the current setting.
14-
OK: Used to confirm the time setting and modification.
15-
COOL/HEAT (inner located): Press this button with a nee-
dle of 1mm to shift mode between COOL only and
COOL&HEAT. During setting, back light will be lightened.
Factory default mode is COOL &HEAT.
16-
ECO: Activate or turn off economic operation mode. It is
suggested to turn on this function when sleeping. (Only
available when remote controller is used with correspon-
ding unit).
and
are
37
Publicidad
