ESAB MobileFeed 201 AVS Instrucciones De Uso página 10

2 INTRODUCTION
CAUTION!
Read and understand the instruction manual before
installing or operating.
CAUTION!
Class A equipment is not intended for use in residential
locations where the electrical power is provided by the
public low-voltage supply system. There may be potential
difficulties in ensuring electromagnetic compatibility of
class A equipment in such locations, due to conducted as
well as radiated disturbances.
ESAB can provide you with all necessary welding protection and accessories.
2 INTRODUCTION
2.1 Overview
The MobileFeed 201 AVS (Arc Voltage Sensing) is a portable wire feeder. The unit is
powered entirely on the arc voltage from a constant current (CC) or constant voltage (CV)
welding power source. It operates with reversed polarity, Direct Current Electrode Positive
(DCEP), or straight polarity, Direct Current Electrode Negative (DCEN). The MobileFeed 201
AVS is available with two connections, EURO and TWECO. A remote voltage control option
is available with the Warrior power source (requires software update to the power source).
The unit is designed for use with hard, soft, and cored electrodes (gas-shielded or
self-shielded) from 0.030" (0.8 mm) to 5/64" (1.98 mm) diameter with a wire feed speed from
50 to 750 in/min (1.3 - 19.0 m/min). The feeder components are totally enclosed in a rugged
case.
ESAB's accessories for the product can be found in the "ACCESSORIES" chapter of
this manual.
2.2 Equipment
The MobileFeed 201 AVS is supplied with:
• Instruction manual
• Voltage pickup cable with clamp
3 TECHNICAL DATA
NOTE!
The MobileFeed 201 AVS is not recommended for short circuiting transfer using
constant current power sources due to the limited short circuit current available
on constant current power sources.
Wire feed speed
Primary input (open circuit voltage or arc voltage) Not for use with AC power
Minimum
0558 012 084
MobileFeed 201 AVS
50 – 750 in/min (1.3 – 19.0 m/min)
14.0 V DC
- 10 - © ESAB AB 2015