ESAB MobileFeed 201 AVS Instrucciones De Uso página 24

5 OPERATION
.045"
1/16" 26 V 27 V
290 A 340 A
Al / Si Aluminum
Diameter
200 / 5.1
3/64 25 V 110 A
1/16 26 V 200 V
Al / Mg Aluminum
Diameter
150 / 3.8
3/64" 22 V 100 A
1/16"
5.3.4 MobileFeed 201 with CC Power Sources
1. Select the weld current/arc voltage needed for the wire type and diameter to be welded,
see section "Weld data table" in this chapter.
2. Set the power supply current with the knob for setting the current on the front panel of
the power source.
3. Set the arc voltage value taken from the weld data table using the knob for setting the
voltage on the wire feeder.
4. Set the wire feed speed value taken from the weld data table using the knob for setting
the wire feed speed on the wire feeder.
5. Strike an arc and adjust it to the desired wire speed with the knob for setting the wire
feed speed.
5.3.5 MobileFeed 201 with CV Power Sources
1. Select the arc voltage/weld current needed for the wire type and diameter to be welded,
see section "Weld data table" in this chapter.
2. Set the power supply voltage with the knob for setting the voltage on the power source or
use the optional remote voltage control in the wire feeder.
3. Read the wire feed speed at the top of the column in the "Weld data table" for the chosen
wire type, diameter, and arc voltage/weld current.
4. Use the "Weld data table" to determine the position of the knob for setting the wire feed
speed on the wire feeder.
5. Strike an arc and adjust the arc length as needed with the knob for setting the wire feed
speed.
0558 012 084
25 V 26 V
260 A 280 A
30 V
400 A
Wire Feed Speed
(inch/min) / (m/min)
250 / 6.35 300 / 7.6
25 V 140 A 26 V 150 V
23 V 260 A 30 V 300 A
Wire Feed Speed
(inch/min) / (m/min)
200 / 5.1 250 / 6.35
23 V 150 A 23 V 175 V
23 V 200 A 25 V 250 A
- 24 -
27 V 28 V 30 V
300 A 320 A 340 A
350 / 8.9 400 / 10.2
26 V 190 A 27 V 205 A
32 V 350 A
300 / 7.6 350 / 8.9
24 V 190 A 25 V 205 A
27 V 280 A 27 V 290 A
450 / 11.4
27 V 220 A
400 / 10.2
25 V 220 A
28 V 340 A
© ESAB AB 2015