Hupfer CoolMultiMobil Manual De Instrucciones página 77

Operating instructions
Removing and installing the door flap
The door flap can be removed as follows.
1. Fully open the roller shutters.
2. Loosen the left and right clips.
3. Remove the flap.
�� You have removed the flap.
The wire pin [1] can be removed for cleaning and easier insertion.
The flap can be replaced by reversing the steps described above.
Fig. 5: Removing and installing the door flap
Cleaning the roller shutters
1. Disconnect the CoolMultiMobil from the power supply.
2. Remove all trays and containers from the CoolMultiMobil.
3. Remove removable components 1 to 4 in numerical order.
4. Close only one roller shutter. The other roller shutter remains
open.
5. Clean the outside and inside of the roller shutter. Clean the guide
rails.
6. Dry the outside and inside of the roller shutter and the guide rails.
7. Repeat the same steps for the second roller shutter.
8. Reinstall all components in reverse numerical order (from 4 to 1).
�� The roller shutters have been cleaned.
CoolMultiMobil
32 / 39