Hupfer CoolMultiMobil Manual De Instrucciones página 78

Operating instructions
Emptying the condensation collector
During operation, air humidity condenses on cold components. The
condensate is collected in a container underneath the CoolMultiMobil.
The container must be emptied and cleaned after each use and at
least 1× per day. The amount of condensate depends on the air
humidity and the ambient temperature.
1. Remove the condensation collector from the holder.
2. Empty the condensation collector.
3. Clean the condensation collector.
4. Slide the condensation collector into the holder.
�� The condensation collector has been emptied.
Cleaning the floor pan
1. Disconnect the CoolMultiMobil from the power supply.
2. Remove all trays and containers from the CoolMultiMobil.
3. Position the CoolMultiMobil over a drain.
4. Remove condensation collector 10.
5. Remove components 2 and 3 and, if necessary, component 1.
6. Unplug the fans from the sockets.
7. Remove component 9.
8. Clean the condensate pan.
9. Rinse the siphon with plenty of water and detergent.
10. Clean the removed components as required.
11. Dry all components.
12. Reinstall the components in the reverse order.
13. Connect the fans to the sockets.
�� The floor pan has been cleaned.
CoolMultiMobil
33 / 39