Oase AquaMax Eco Expert Serie Puesta En Marcha página 13


Avoid exposing any unit components to direct sunlight for extended periods of time, as this
can lead to damage. If necessary, use a protective cover.
Connecting the control system
The pump can be operated with or without the control system.
• The control system makes it possible to regulate the pump power.
• Without the control system, the pump runs permanently at full power.
Compatible control systems (accessories):
• Eco Control
Intelligent control system for one pump.
• Incenio FM-Master Home/Cloud
Garden Controller Home/Cloud
Up to 10 OASE Control-compatible units (pumps, filters, lights) can be controlled using the
"OASE Control" app.
For information on this topic, visit www.oase.com and navigate to the section "Smart garden
controls and lighting".

For information, please refer to the operating manual.
Connecting and disconnecting the OASE Control plug connection
NOTE
The unit will be damaged, if water enters the plug connector.
Connect the plug connector or place the protective cap on it.

 Ensure that the rubber seal is clean and fits exactly.
 If the rubber seal is damaged, it must be replaced. When the plug connector is disconnected,
the rubber seal must be replaced if it is older than 2 years.
Always secure the plug connector or the protective cap with the two screws.

Submerged installation of the pump
Connecting
 B
Do not plug the power plug into the socket yet!
EN
PLX0004
13