Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
C
• Place the pump horizontally on a stable surface.
• Ensure secure and stable positioning of the pump.
• For muddy or soiled water, we recommend installing the pump or intake-side components
(skimmer, satellite filter, base outlet, etc.) above ground level. This decreases intake of parti-
cles and increases the service life of the impeller unit.
• Only operate the pump when it is covered in at least 10 cm of water. Otherwise it may draw in
air.
The pull rope allows you to simply pull the pump from the water.
− Fasten the pull rope on the bottom filter casing through the round openings and make a
knot.
Install the unit at a dry place
For information, please refer to the operating manual.
Commissioning/start-up
NOTE
The unit will be destroyed if it is operated with a dimmer. It contains sensitive electrical compo-
nents.
Do not connect the unit to a dimmable power supply.
NOTE
Never allow the pump to run dry. Otherwise the pump may be destroyed.
Only operate the pump when it is submerged or flooded.
Switching ON/OFF
• Switching on: Plug the power plug into the outlet.
– The unit is switched on after a brief starting phase.
• Switching off: Pull the power plug from the outlet.
Environmental Function Control (EFC)
When started up and then every 20 ... 40 minutes the pump automatically performs a pre-pro-
grammed self-test (Environmental Function Control (EFC)). The pump detects if it is running dry
/ clogged or submerged. The pump shuts down automatically after 60 to 120 seconds if it runs
dry/is blocked. In the event of a malfunction, disconnect the power supply and "flood the pump"
or remove the obstacle. Afterwards, the unit can be restarted.
14
Publicidad
