Briggs & Stratton Speed Clean Manual Del Usuario página 12

if youhave any problems operating yourpressure washer,
please c arl thepressure washer helpline at(800} 7 43-4115,
Pressure Washer Location
Carbon Monoxide Poisoning
A WARNING POISONOUS GAS HAZARD. Engine
exhaust contains carbon monoxide, a poisonous
gas that could kill you in minutes. You CANNOT
smell it, see it, or taste it. Even if you do not
smell exhaust fumes, you could still be exposed to carbon
monoxide gas.
, Operatethis product ONLY outside far away from windows,
doors and vents to reducethe risk of carbon monoxide gas
from accumulating and potentially being drawn towards
occupied spaces.
* Install battery-operated carbon monoxide alarms or plug-in
carbon monoxide alarms with battery back-up according to the
manufacturer's instructions. Smoke alarms cannot detect
carbon monoxide gas.
* DO NOTrun this product inside homes, garages, basements,
crawlspaces, sheds, or other partially-enclosedspaces even if
using fans or opening doors and windows for ventilation.
Carbon monoxide can quickly build up in these spacesand can
finger for hours, even after this product has shut off.
* ALWAYS placethis product downwind and point the engine
exhaust away from occupied spaces.
if you start to feel sick, dizzy, or weak while using this product,
shut it off and get to fresh air RIGHTAWAY. See a doctor. You
may havecarbon monoxide poisoning.
Exhaust Port
Pointed away from
occupied spaces
New te Start Your Pressure Washer
To start your pressure washer for the first time, follow these
instructions step-by-step. This starting information also
@pries if you have let the pressure washer sit idle for at bast
a day.
1. Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.5 gallons per minute and no less than 20 PSi at
pressure washer end of garden hose. DO NOT siphon
supply water.
2. Checkthat high pressure hose is tightly connected to
spray gun and pump. See Assembly section.
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure washer
pump.
NOTICE DO NOT run the pump without the water supply
connected and turned on.
. Damage to equipment r esultingfrom failureto follow this
instructionwill voidwarranty.
5. Turn ONwater, point gun in a safe direction, press red
button and squeezetrigger to purge pump system of air
and impurities.
6. Attach nozzle extension to spray gun. Tighten by hand.
.
Choose spray tip you want to use, puff back on collar of
nozzle extension, insert spray tip and releasecollar. Tug
on spray tip to make sure it is securely in place. See
How to Use Spray Tips.
8. Push engine rocker switch (A) to on position (Ier ON).
Risk ef Fire Clearances
A WARNING Exhaust heat/gases could ignite
combustibles, structures or damagefuel tank
causing a fire, resulting in death or serious injury.
* Keepat least 5 fL (1.5 m) clearanceon all sides of pressure
washer including overhead.
12 BRIGGSandSTRATTON.CONI