Briggs & Stratton Speed Clean Manual Del Usuario página 20

Changing Engine Oil
if you are using your pressure washer under extremely dirty
or dusty conditions, or in extremely hot weather, changethe
oil more often,
A CAUTION Avoid prolonged or repeatedskin contact
with used motor oil,
, Usedmotor oil hasbeenshownto causeskincancerin certain
Thoroughly washexposed areaswith soapandwater.
KEEPOUT OFREACHOFCHILDREN.DON'T
POLLUTE.CONSERVE RESOURCES. RETURN
USEDOiL TO COLLECTION CENTERS.
Service Air Cleaner
Your engine will not run properly and may be damaged if
you run it with a dirty air cleaner. Service more often if
operating under dirty or dusty conditions,
To sewice the air cleaner, feiiew these steps:
1. Slide air cleaner lever (A) to unlock (_) position and
tilt cover (B) down.
Change eli while engine is still warm frem running, as
fellows:
1, Drain fuel tank by running pressure washer until fuel
tank is empty.
2, Disconnect spark plug wire and keep it away from
spark plug.
3, Cleanarea around oil fill, remove oil fill cap/dipstick,
Wipe dipstick dean.
4, Tip your pressure washer to drain oil from oil fill into a
suitable container making sure you tip your unit away
from spark plug. When crankcase is empty, return
pressure washer to upright position.
5, Slowly pour recommendedoil (about 20 oz (0,6 I_ into
oil fill opening. Pauseto permit oil to settle, Fill to FULL
mark (top hole) on dipstick.
6, Wipe dipstick dean each time oil level is checked, DO
NOT overfill,
7, Replace and tighten dipstick.
8, Wipe up any remaining oil.
9, Reconnect spark plug wire to spark plug.
2, Carefully remove air cleaner to prevent debris from
falling into carburetor.
3, Wash foam air cleaner (C) in liquid detergent and
water. Squeezedry in a clean cloth.
4, SATURATE foam air cleaner in engine oil and squeeze
in a clean cloth to remove excess oil,
5. Reinstall clean or new foam air cleaner in base (D),
6. Tilt cover up and slide lever to lock (_) position.
Service Spark Plug
Changingthe spark plug will help your engine to start easier
and run better,
1, Cleanarea around spark plug,
2, Remove and inspect spark plug.
3, Replace spark plug if electrodes are pitted, burned or
porcelain is cracked. Use the recommended
replacement plug. See Specifications,
4, Check electrode gap with wire feeler gauge and reset
spark plug gap to recommended gap if necessary (see
Specifications).
5, Install spark plug and tighten firmly,
28 BRIGGSandSTRATTON.CONI