Briggs & Stratton Speed Clean Manual Del Usuario página 15

Usage
T ips
° For most effective cleaning, keep spray tip from 8 to
24 inches (20 to 61 cm) away from cleaning surface.
, if you get spray tip too close, especially using a high
pressure spray tip, you may damage surface being
cleaned.
, DO NOT get closer than 6 inches (15 cm) when
cleaning tires.
Cleaning and Applying Detergent
,_kWARNING Chemical Burn Hazard.
Chemicals could cause burns resulting in death
or serious injury.
* DO NOTuse caustic liquid with pressure washer.
* Use ONLY pressure washer safe detergents/soaps. Follow aiI
manufacturers instructions.
To apply detergent, feiiew these steps:
1. Review use of spray tips.
2. Prepare detergent solution as required by job.
3. Place end of detergent siphoning tube into detergent
container.
NOTICE Make sure the end of tube is fully submerged in
detergent while applying detergent.
NOTICE Contact with the hot muffler could damage
detergent siphoning tube.
, When inserting the siphon nto a detergent solution bottle, route
the tube so as to keep it from inadvertently contacting the hot
muffler_
4. Make sure black detergent spray tip is installed.
NOTICE Detergent cannot be applied with the high pressure
spray tips (White, Yellow or Red.
5. Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray
gun and pump. Turn on water.
NOTICE You must attach all hoses before you start the
engine.
, Starting the engine without all the hoses connected and without
the water turned ON could damage the pump.
* Damageto equipment resulting from failure to follow this
instruction will void warranty.
6. Start engine following instructions How to Start Your
Pressure Washer.
7. Apply detergent to a dr}' surface, starting at lower
portion of areato be washed and work upward, using
long, even, overlapping strokes.
8. Allow detergent to "soak in" for 3-5 minutes before
washing and rinsing. Reapply as neededto prevent
surface from drying. DO NOTallow detergent to dr}' on
(prevents streaking).
NOTICE You must flush the detergent siphoning system
after each use by placing the tube into a bucket of clean
water, then run the pressure washer in low pressure for 1-2
minutes.
Pressure Washer Rinsing
For Rinsing:
1. Remove black detergent spray tip from nozzle
extension.
2. Select and install desired high pressure spray tip
following instructions How to Use Spray Tips.
3. Keep spray gun a safe distance from areayou plan to
spray.
A WARNING Kickback from spray gun could cause you
to fall resulting in death or serious injury.
° Operate pressure washer from a stable surface.
° Be extremely careful if you must use the pressure washer from
a ladder, scaffolding, or any other similar location.
* Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks bacL
4. Apply a high pressure spray to a small area and then
check surfacefor damage, if no damageis found, you
can assumeit is okayto continue rinsing.
5. Start at top of areato be rinsed, working down with same
overlappingstrokes asyou used for cleaning.
15