Briggs & Stratton Speed Clean Manual Del Usuario página 23

Pump has following problems:
failure to producepressure,
erratic pressure, chattering, less
of pressure, low water volume.
Detergentfails _o mix with spray.
Enginewiii not start; startsand
runs rough or shutsdown during
operation.
Engine lackspower.
Cause
1. Low pressure spray tip installed.
2. Water inlet is blocked.
3. inadequatewater supply.
4. Inlet hose is kinked or baking.
5. Clogged inlet hose screen.
6. Water supply is over IO0°F.
7. High pressure hose is blocked or
leaks.
8. Spray gun leaks.
9. Spray tip is obstructed.
10. Pump is faulty.
1. Detergentsiphoning tube is not
submerged.
2. Detergentsiphoning tube/filter is
clogged or cracked.
3. High pressure spray tip installed.
4. Check ball stuck in detergent
siphoning system.
1, Engine rocker switch set to of_(O or
Off) position.
2. Low oil level.
3. Dirty air cleaner. ....
4. Out of fuel........ ..............
5. Stab fuel.....................
....... Spark connected to
spark .............
in fuel.
Excessively rich fuel mixture.
irty air filter.
Correction
1. Replacewith high pressure spray tip.
2. Gear inlet.
3. Provide adequatewater flow.
4. Straighten inlet hose, patch leak.
5. Check and clean inlet hose screen.
6. Provide cooler water supply.
7. Gear blocks in outlet hose.
8. Replacespray gun.
9. Clean spray tip.
10. Contact local service facility.
1. insert detergent siphoning tube into
deter(
filter/detergent
tube.
;e with low pressure spray tip.
4 Unstick check ball as described in
Detergent Sip,_oningCheckBall.
1. Set engine rocker switch to on (Eor
On) position.
2. Fill crankcase to proper level.
3. Clean or replace air cleaner.
4. Fill fuel tank.
5. Drain fuel tank; fill with fresh fuel.
6. Connect wire to spark plug.
7, Replacespark plug.
8. Drain fuel tank; fill with fresh fuel.
9. Contact local service facility.
Replaceair filter.
23