Handle Height - Snapper S22675 Manual Del Operador

Handle Height
1. Remove the vangnuts (A, Figure 4), washers (not
shown), and bolts from the right and left handle
brackets (B).
Note: Do not remove the lower set of handle hardware (D).
2. Adjust the handle to a higher or lower height adjustment
hob (C).
3. Reinstall the bolts, washers and wingnuts removed in
Step 1.
Handle Height (optional quick°release)
1. Turn the knobs (A, Figure 4a) on either side of the lower
handle (B) to retract the locking pins. Align the lower
handle with the desired set of hobs in the handle
brackets (C). Turn the knobs to releasethe locking pins
and secure the lower handle.
Note: Do not remove the lower set of bolts and nuts securing
the lower handle.
Figure 4: Adjusting the handle height
Figure 4: Adjusting the handle height (qu£k-release)