Replacement Of The Fuses - Sonel CMM-40 Manual De Uso


Insert the battery into battery holder, observing the correct po-
larity,

Put the battery cover back in place. Secure with the screws.
Illustration 3. Battery cover of the CMM-40 meter
8
To avoid electric shock, disconnect the test leads from any
source of voltage before removing the meter cover.
In order to replace the fuses it is necessary to do the following:

Disconnect the test leads from the meter and place rotational
selector in the position OFF,

Remove the battery cover (two "B" screws) and the battery,

Remove the six "A" screws securing the rear cover,

Gently remove the old fuse and install the new fuse into the
holder,

Replacement of the fuses

WARNING:
CMM-40 – USER MANUAL
65