Publicidad
Step 9
å
Fasten one of each EXTENSION BLOCK (YY and ZZ)
to the UPRIGHT (C3). Use six SILVER 1-1/8" FLAT
HEAD SCREWS (10S).
å
NOTE: You should start each SCREW a few turns
before completely tightening any of them.
SILVER 1-1/8" FLAT HEAD SCREW
(6 used in this step)
The hole is closer
to this edge.
www.sauder.com/service
10S
ZZ
YY
C3
411201
Some assembly
(and snacks) required.
The large hole must be here.
Edge with
CAM DOWELS
Page 15
Publicidad
