Publicidad
Step 40
å
To make adjustments to the drawer, loosen SCREW #4
in the SLIDES a 1/4 turn, then turn the cam clockwise or
counter-clockwise. Notice how the drawer raises or lowers
as you turn the cam. By adjusting the drawer this way, it
will help the DRAWER FRONT line up better when closed.
Tighten the SCREWS when finished with adjustments.
Loosen screw #4 a 1/4 turn, turn the cam a 1/4 turn
maximum in both the clockwise and counter-clockwise
directions to make adjustments, and then tighten screw #4.
The higher the screw in the oblong hole,
the higher your drawer front will be. The
lower the screw, the lower the drawer front.
Page 46
Cam
411201
13
Almost time to
celebrate! With a nap.
www.sauder.com/service
Publicidad
