Publicidad
Step 18
å
Turn two BLACK 9/16" FLAT HEAD SCREWS (32S) into
the RIGHT END (A3) until the shoulders of the SCREWS
rest on the surface of the END.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the remaining END MOLDING (M73) onto the
RIGHT END (A3). Line up the groove in the MOLDING
over the heads of the SCREWS in the END.
å
NOTE: The MOLDING should be centered on the END.
å
NOTE: If the MOLDING comes up off of the SCREWS,
remove it and slide it on again.
Shoulder
Apply pressure with your hands
as you guide the MOLDING over
the SCREWS and onto the END.
Page 24
BLACK 9/16" FLAT HEAD SCREW
(2 used in this step)
M73
411201
32S
A3
www.sauder.com/service
Publicidad
