Publicidad
Step 26
å
Carefully turn your unit over onto its front edges. Unfold the BACK (F2) and lay it over your unit.
å
IMPORTANT: Your unit must be "squared up" to the BACK (F2) before fastening. Make equal margins along the top and
bottom edges of the BACK (F2). Then, make equal margins along the side edges of the BACK (F2). Push on opposite
corners of your unit if needed to make it "square".
å
BACK INSTALLATION:
1.
Begin fastening the BACK (F2) using four BLACK 9/16" EURO SCREWS (62S) through the four holes shown at positions 1.
2.
Finish fastening the BACK (F2) to your unit using the NAILS (1N) through all remaining holes.
3.
NOTE: Be sure to tap NAILS into the holes that line up over the UPRIGHT (C3).
BLACK 9/16" EURO SCREW
(4 used in this step)
NAIL
(43 used in this step)
Page 32
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
62S
1N
1
1
These holes must line up
over the UPRIGHT (C3).
F2
411201
8
These holes
must be here.
1
1
www.sauder.com/service
Publicidad
