Bosch NET 74 Serie Manual De Uso Y Cuidado página 9

The elements
Single element Single elements have only one size cooking sut#ace.
Choose the correct element.
Choose a pan that matches the size of the element.
Dual element
On these elements, the size can be changed. The element must be turned on.
To turn off the outer ring:
Touch the _) symbol. The indicator lamp goes out.
To turn on:
Touch the _) symbol again. The indicator lamp comes on.
Hot surface indicator
lo
I I I I
The cooktop has a hot surface indicator for each element. It shows you which
elements are still hot. The hot surface indicator has two levels.
If an H is shown on the display, the element is still hot. You could use it, for example,
to keep a small quantity of food warm or to melt a chocolate coating.
As the element continues to cool, the display changes to h. The display goes out
once the element has cooled sufficiently.
The hot sul#ace indicator will automatically come on after a power failure. The
display light's up for approximately 30 minutes. The display goes out when you
briefly turn on the hotplate again.
Operation
Power key
Turning power on
Turning power off
Notes
The power key turns on the electronics for the touch key panel. Your cooktop is now
ready to use.
Touch ON/OFF until the power on lamp • and the - element indicators light up.
Touch ON/OFF until the power on lamp • and the - element indicators go out. This
turns off all the elements. The hot surface indicator stays on until the elements have
cooled sufficiently.
The cooktop turns off automatically once all of the elements have been off for more
than 20 seconds.
If the surfaces are still hot when the cooktop is turned back on, H/h and - alternate
in the element indicator display.
9