Publicidad
Figure 3 Mounting examples (2)
1 PVS insertion mount
2 Insertion mount
4.2 Connect the sensor to an SC Controller
Use one of the options that follows to connect the sensor to an SC Controller:
• Connect the sensor to an sc digital gateway, then connect the sc digital gateway to the SC
Controller. The digital gateway converts the analog signal from the sensor to a digital signal.
• Install a sensor module in the SC Controller. Then, connect the sensor to the sensor module. The
sensor module converts the analog signal from the sensor to a digital signal.
Refer to the instructions supplied with the sensor module or sc digital gateway.
Section 5 Operation
5.1 User navigation
Refer to the controller documentation for the touchscreen description and navigation information.
5.2 Configure the sensor
Use the Settings menu to enter identification information for the sensor and to change options for
data handling and storage.
1. Select the main menu icon, then select Devices. A list of all of the available devices shows.
2. Select the sensor and select Device menu > Settings.
3. Select an option.
• For sensors connected to a pH/ORP module, refer to
• For sensors connected to an sc digital gateway, refer to
8 English
3 Immersion mount
4 Immersion mount, ball float
Table
1.
Table
2.
Publicidad
