Publicidad
Idiomas disponibles
Idiomas disponibles
•
To reduce vibrations and noise, it is recommended a space be left around the washing
machine.
•
Do not place nearby any heat source (hobs, irons, ovens, etc.). on the washing
machine.
Installing under a worktop
The washing machine can be installed under a worktop
provided you leave a minimum clearance of:
3 cm above the washing machine
8 cm on each side of the washing machine
8 cm behind the washing machine.
Adjusting the feet
The appliance must be level and balanced on its feet so that it operates silently and
without vibration. To do this, adjust the feet using a spirit level.
CAUTION: do not use a tool to loosen the locking nuts: you could damage them.
1
2
1.
Unscrew the foot locking nuts manually.
2.
Adjust these by turning the feet upwards or downwards.
3.
When the appliance is level and balanced, tighten the locking nuts again.
COMMENTS:
•
Never place cardboard, wooden wedges or similar elements under the appliance to
offset irregularities in the floor.
•
Check that the water supply hose is not kinked, cracked or crushed by the feet.
46
3 cm
8 cm
8 cm
2
3
Connections
Connecting to the water supply
IMPORTANT:
•
Your washing machine is designed to be connected to a cold-water supply.
•
Your washing machine must be connected to the water supply using a new supply
hose. Do not reuse old supply hoses.
•
Be sure to install the rubber seals provided at each end of the hose.
•
For the washing machine to operate correctly, the water supply pressure must be
between 50 kPa and 800 kPa.
•
If in doubt, consult a qualified plumber.
1.
Connect the elbow end of the hose to the threaded inlet at the rear of the appliance.
2.
Connect the other end of the hose to the water tap. Then ensure the nut is tightened
correctly by hand.
3.
Open the tap fully after connecting the hose to check the installation is leaktight.
To prevent any water leak or water damage, leave the tap closed when the washing
machine is not used for a prolonged period of time.
47
Publicidad
