essentiel b ELF1014-4b Instrucciones De Uso página 39

Problems
The laundry results are not Your laundry is too soiled
satisfactory. for the program you have
selected.
The amount of detergent
used was insufficient.
An amount of laundry
exceeding the maximum
load was placed into the
appliance.
The water in your region is
hard.
Excess foam. Error code You have used too much
"E4" will be displayed on the detergent.
screen.
You have used too much
detergent for a small
amount of slightly dirty
laundry.
The door doesn't open. Error The appliance is soaking
code "E7" will be displayed or draining. The door only
on the screen. opens for a few minutes
after the program stops.
If the door is blocked, unplug the electrical supply from
the washing machine and then reconnect it. Wait 2-3
minutes and then open the door.
76
Possible Causes What To Do
Select the appropriate
program (refer to the
table of programs). If
the laundry is very dirty,
carry out a prewash.
Use a greater amount of
detergent in accordance
with the laundry.
Do not exceed the
washing machine's
maximum load for each
program (refer to the
table of programs).
Use the amount of
detergent indicated by
the manufacturer.
Comply with the
amounts recommended
on the packaging.
Adjust the quantity of
detergent to the amount
of laundry.
Wait until the red light
goes out.
Check that the appliance
is not rinsing or spinning.
Pull firmly on the handle
to open.
Problems Possible Causes
The washing machine The feet of your appliance
vibrates or trembles. are poorly adjusted.
The transport safety bolts
have not been removed.
There is a small quantity of
laundry in the appliance.
The appliance is in contact
with another appliance or
any other object.
The washing machine does The water tap is closed.
not fill with water. Error code
The water supply hose is
"E2" will be displayed on the
kinked.
screen.
The water supply filter is
clogged.
The door is incorrectly
closed, or a garment is
trapped in the door.
The washing machine does The drain hose is kinked.
not drain the water. Error
The drain pump filter is
code "E3" will be displayed
clogged.
on the screen.
The washing machine drains The end of the drain hose
as soon as it is filled. is too low in relation to the
appliance.
There is water on the floor. The water supply hose and/
or drain hose is damaged.
The type of detergent is
not suitable or there is
an excessive quantity of
detergent.
What To Do
Level the appliance by
correctly adjusting the
feet.
Remove the transit
bolts.
Add laundry to the
appliance.
Ensure that nothing
touches the appliance.
Open the water supply
fully.
Check the water supply
hose.
Clean the water supply
filter.
Check and close the
door correctly.
Check the drain hose.
Clean the drain pump
filter.
Place the drain hose
at an appropriate
height (refer to the
"Connecting to the
drain" paragraph).
Check the water supply
and drain hoses and
replace these with new
ones if necessary.
Refer to the "Preparing
for washing" section.
77