essentiel b ELF1014-4b Instrucciones De Uso página 36

cycle and at each washing phase.
- adjusts the amount of water required;
- determines the duration of the washing cycle;
- controls rinsing according to the type of textile to be washed;
- adjusts the drum rotation rate according to the type of textile;
- Detects the presence of foam, increasing the amount of rinse water as needed;
- adjusts the spin speed according to the load, thus avoiding any imbalance.
4) ANTI-CREASE INDICATOR
This LED indicates the selection of the anti-crease option.
If the door is not properly closed, the LED will continue to flash for approximately 7
seconds, after which the start command will be cancelled. In this case, close the door
and then press the START/PAUSE button again
Close the door before pressing the START/PAUSE button
5) TEMPERATURE SELECTION INDICATOR
The LEDs indicate the washing temperature of the selected program. The temperature
can be changed using the temperature selector, but cannot be set to more than the
maximum allowed for each program. If you wish to do a cold wash, all LEDs must be off.
6) SPIN SPEED SELECTION INDICATORS
The spin speed indicator displays the spin speed of the selected program. The spin
speed can be modified or the spin cycle cancelled by pressing the spin speed selector.
7) OPTION INDICATORS
The LEDs indicate the options that can be selected (using the option buttons).
8) DEGREE OF SOILING INDICATOR
Once the program has been selected, the indicator will display the degree of soiling
associated with that program.
Then select, if desired, a different degree of soiling.
9) SPECIAL PROGRAM INDICATORS
The LEDs indicate the options that can be selected (using the option buttons).
70
.
.
Duration of the program
• When a program is selected, the screen automatically displays the cycle time, which
may vary depending on the options selected.
• The cycle time remaining will be displayed while the program runs.
• The washing machine calculates the remaining cycle time of a program based on a
standard load. During the cycle, it corrects this duration according to the composition
of the load.
End of program
At the end of the program, the screen displays "End". Wait until the door lock light
goes out. Set the program selector to the OFF position to turn the appliance off.
Remove the laundry and leave the door ajar to preserve the door seal and prevent
odours.
71