Publicidad
Idiomas disponibles
Idiomas disponibles
Getting Started
Detaching the Front Panel
You can detach the front panel of this unit to
prevent theft.
1
Press and hold OFF until the unit turns
off, press the front panel release button
, then pull the panel towards you to
remove.
Caution alarm
If you turn the ignition switch to the OFF position
without detaching the front panel, the caution
alarm will sound for a few seconds. The alarm will
only sound if the built-in amplifier is used.
Serial numbers
Make sure the serial numbers on the bottom of the
unit and the back of the front panel are matched
correctly. Otherwise you cannot make BLUETOOTH
pairing, connection and disconnection by NFC.
Attaching the front panel
Resetting the unit
Before operating the unit for the first time, after
replacing the car battery, or changing the
connections, you must reset the unit. Press RESET
on the inner panel with a ball-point pen, etc., after
detaching the front panel.
Note
Pressing RESET will erase the clock setting and some
stored contents.
Switching the FM/AM Tuning
Step
(except for Argentine models)
Set the FM/AM tuning step of your country. This
setting appears only while the source is off and
the clock is displayed.
1
Press MENU, rotate the control dial to
select [SET GENERAL], then press it.
2
Rotate the control dial to select [SET
TUNER-STP], then press it.
3
Rotate the control dial to select from [SET
50K/9K], [SET 100K/10K] or [SET 200K/
10K], then press it.
Setting the Clock
1
Press MENU, rotate the control dial to
select [SET GENERAL], then press it.
2
Rotate the control dial to select [SET
CLOCK-ADJ], then press it.
The hour indication flashes.
3
Rotate the control dial to set the hour
and minute.
To move the digital indication, press SEEK +/–.
4
After setting the minute, press MENU.
The setup is complete and the clock starts.
To display the clock
Press DSPL.
7
GB
Publicidad
