ENGLISH
as follows:
- Open the door fully
- Fully open the left and right hinge levers
- Hold the door as shown in the third picture.
- Gently close the door until the left and right hinge levers are engaged in part B of the
door as shown in the third picture.
- Remove the hinge hooks from their location following the arrow shown in Figure 4
- Rest the door on a soft surface.
- To replace the door, repeat the above steps in reverse order.
Removing the inner glass - Fig. 7
- Double oven door: remove the seal by unscrewing the screws
- Carefully remove the inner glass
- Clean the glass with a suitable cleaner. Dry it thoroughly and place it on a soft surface.
- Then you can also clean the inside of the outer glass.
Steam cleaning - Fig.8
This function helps to remove food residues from inside the oven. This method is only
effective for the removal of light, non-fouling dirt. It is not effective to remove stubborn
stains caused by cooking. This function can only be used when the oven is cold.
Cleaning procedure:
- Remove all shelves, plates, racks, trays, etc.
- Prepare a solution of water (85%), white vinegar (10%) and dish detergent (5%) and
spray generously on the door, side walls and rear wall of the oven cavity
- Pour 40 ml of water into the base of the oven cavity
- Close the door. Set the Steam-Assisted Cleaning function and the temperature to
130 °C.
- Turn off the oven after 18 minutes.
- Allow to cool to a safe level before wiping the inside surface with a damp cloth.
- Dry the entire interior properly with a cloth or absorbent paper. WARNING: make
sure the oven is completely cooled down. Danger of burns.
Note
- Slight differences in colour in the front part of the device are caused by the use of
different materials, like glass, plastic, and metal.
- The shadows on the door panels, which look like stripes, are due to reflections from
the interior lighting.
- Enamel is made at very high temperatures. This can cause a slight colour variation.
This is completely normal and does not affect the device operation. The edges on thin
trays cannot be completely enamelled. As a result, these edges can be rough. This
42
HORNO INTEGRABLE EVVO H25 INOX / BLACK / WHITE