Motorola Solutions IMPRES NNTN8845 Guia Del Usuario página 12

MN002406A01-AL
Chapter 1 : Operational Safety Guidelines
1.2
Charging Procedure
Prerequisites: Turn off the radio.
NOTE: You can only turn on the radio when the radio is transmitting data wirelessly before
charging a radio with an IMPRES 2 or IMPRES battery.
Procedure:
1 Plug the charger end of the power supply cord into the power receptacle located at the back of
the charger.
2 Plug the wall receptacle end of the power supply cord into the appropriate AC outlet. A
successful power-up sequence is indicated by a Single Green Blink on the charger indicator.
3 Insert an IMPRES 2 or IMPRES battery, or a radio with an IMPRES 2 or IMPRES battery into
the charger pocket.
• Aligning battery contacts with the charger contacts.
• Pressing the battery into the pocket, ensuring complete contact between charger and battery
contacts.
4 To remove a radio, IMPRES 2, or IMPRES battery from the charger, pull straight up until the
battery completely clears the charger housing.
1.2.1
Charger Back View
The following figure shows the backview of the charger.
Figure 1: Charger (Back View)
Table 1: Charger (Back View) Description
Item Number Description
1 Programming port. Use this port to program the charger.
2 Dual USB ports. Power source to wireless accessories and fleet management.
3 DC inlet. Connect to power supply.
12
1
2
3