Briggs & Stratton Walk Behind Lawn Mower 19/48cm Manual Del Operario página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 56
Assembly
ASSEMBLE THE HANDLE
1. Loosen the lower handle knobs (A, Fig. 2) at the left and
right handle brackets.
2. Raise the lower handle section to the operating position,
and then tighten the lower handle knobs securely.
NOTICE: Unfold the handle carefully to avoid pinching
and damaging the control cables.
A
Figure 2
3. Remove the protective padding. Loosen the upper
handle knobs (B, Fig. 3) securing the upper handle to
the lower handle.
4. Raise the upper handle section to the operating
position, and then tighten the upper handle knobs
securely.
5. Remove the packing material from the control bar.
B
Figure 3
After assembly, the handle height may be adjusted for
mowing comfort. See Operation section.
8
ASSEMBLE THE GRASS CATCHER
1. Insert the grass catcher frame into the bag with the rigid
floor of the bag to the bottom. Make sure the frame
handle (C, Fig. 4) is outside of the bag and toward the
top.
2. Snap the vinyl retainers (D) over each bar of the frame
opening (E).
C
Figure 4
www.BRIGGSandSTRATTON.com
D
E

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Walk behind lawn mower 21/53cm

Tabla de contenido