Safety Decals - Briggs & Stratton Walk Behind Lawn Mower 19/48cm Manual Del Operario

Operator Safety

SAFETY DECALS

Before operating your walk-behind lawn mower, read the
safety decals installed on your lawn mower. The cautions
and warnings are for your safety. To avoid a personal injury
or damage to your walk-behind lawn mower, understand
and follow all the safety decals.
If any safety decals become worn or damaged and cannot
be read, order replacement decals from your local dealer.
A — Part No. L0101040 Warning Icon Decal
A
Figure 1
en
DESCRIPTION
The walk-behind lawn mower is an engine powered rotary
type mower. The engine drives a cutting blade located
under the mower housing. The blade lifts and cuts through
the grass. The height of cut can be adjusted to give the
lawn the desired finish. The cut pieces of grass are either
collected into a rear mounted grass bag or, on some
mowers, it can be recycled to feed the lawn. Recycling the
cut grass is known as "mulching". Push models require the
operator to push the mower. Self-propelled models have a
rear wheel drive system to make mowing easier.
INTENDED USE/LIMITS OF USE
The walk-behind lawn mower is designed to cut lawn
grass. Any other use is not permitted. It is not designed
to cut grass over 15 cm in length or grass mixed with tall
weeds. The lawn mower is only suitable for private use in a
domestic garden. It is not suitable for cutting grass in public
parks or playing fields.
For assistance with any questions during assembly, please
contact the retailer or service dealer for the unit. Note that
references to "left" and "right" in this manual are from the
operating position.
REMOVE LAWN MOWER FROM CARTON
1. Remove the parts bag and any other loose parts packed
in the carton.
2. Cut the corners of the carton and lay the end panels flat.
3. Remove all packing materials except the padding
between the upper and lower handles and the padding
holding the control bar to the upper handle.
4. Roll the lawn mower off the carton. Check the carton
thoroughly for any additional parts that may have
loosened during shipment.
Assembly
7