Descargar Imprimir esta página

Philips IntelliBridge ED423 Instrucciones De Uso página 27

Publicidad

This service information describes the connection of the IntelliBridge to the GE Carestation 600 Series
anesthesia machine.
Data communication
The IntelliBridge EC10 module supports RS232 serial data communication with the pre-configured
communication settings of the GE Carestation 600 Series anesthesia machine. No further
configuration of the connection parameters is needed.
• Baud rate:
• Word length:
• Stop bits:
Instruction for connection
Connect the IntelliBridge EC5 D-Sub 9-pin connector to either of the RS232 connectors of the GE
Carestation 600 Series anesthesia machine as shown below. Make sure to tighten the screws of the
connector properly.
IntelliBridge EC5 connection to RS232 ports
1
2
3
References
For further service information, refer to the patient monitor service guide.
Service Information
7
19200
7 bits
1
1
GE Carestation 600 Series anesthesia machine
IntelliBridge EC5 ID module
EC5 device label: "GE Carestation 600"
• Parity generation:
• Parity checking:
3
7
Odd
Odd
2
27

Publicidad

loading