Bosch HBE5451UC Manual De Uso Y Cuidado página 11

Switching
the signal tone off
Hold the TIMERS button down until the clock disappears.
After seven minutes, the signal switches off
automatically.
Setting the automatic timer
With the TIMER function, you can set an operating time
duration or program a start and end time.
Automatic switch-off
1. Press the TIMERS button down until the Z_ symbol
blinks.
2. Press the TIMERS button again.
On the display, auto and ou_-' blink.
3. Use the 4- and - buttons to set the operating time
duration.
The operating time duration can be set from 1 minute
to 10 hours.
4. Set the desired heating type and temperature.
The oven starts. The and auto signals light up on
the display, the current time is displayed.
The operating time duration has elapsed
A signal sounds, auto blinks on the display.
1. Switch off the temperature selector and function
selector.
2. Hold the TIMERS button down until the symbol
appears.
The oven switches back to manual mode.
Canceling the operating time duration
To delete the setting, hold the TIMERS button down until
the Z_ symbol blinks on the display. Then press the 4-
and - buttons simultaneously.
Automatic switch-on and switch-off
Baking or roasting starts for the set duration at a later
time which you chose.
1. Press the TIMERS button down until the Z_ symbol
blinks.
2. Press the TIMERS button again.
On the display, auto and o__,_-' b link.
3. Use the 4- and - buttons to set the operating time
duration.
The operating time duration can be set from 1 minute
to 10 hours.
4. Press the TIMERS button again, auto and the/'_
symbol blink on the display.
The end time for the programmed operating time
duration is displayed.
,
Adjust the end time with the 4- and - buttons.
The end time can be set up to 23 hours and 59
minutes.
The oven calculates the start time. After 5 seconds,
the time set is taken over.
The and auto signals go out, the current time is
displayed.
6. Set the desired heating type and temperature.
The oven will begin to heat at the calculated start time.
On the display, the/'_ and auto symbols light up.
The operating time duration has elapsed
A signal sounds, auto blinks on the display.
1. Switch off the temperature selector and function
selector.
2. Hold the TIMERS button down until the symbol
appears.
The oven switches back to manual mode.
Canceling the operating time duration
To delete the setting, hold the TIMERS button down until
the Z_ symbol blinks on the display. Then press the 4-
and - buttons simultaneously.
Basic Settings
You can always make the following basic settings:
Basic setting Options
Acoustic signal o quiet
o middle
o loud*
Time format o 24 h*
o 12 h am/pm
* Factory setting
Adjust the signal volume
The oven must be switched off.
1. Hold the 4- and - button down until the colon blinks
on the display.
2. Press the TIMERS button again.
Signal appears on the display.
3. Press the - button repeatedly until the required
volume is reached.
Changing the time format
The oven must be switched off.
Press and hold the 4- button for 3 seconds. Rm/Pm
appears on the display. To change to the 24 h time
format, hold the 4- button down again for 3 seconds.
11