Publicidad
Idiomas disponibles
Idiomas disponibles
English
12. Attaching and detaching the chip cover (Fig. 9)
WARNING
To prevent accidents when attaching or
detaching the chip cover, make sure the unit is
switched off and the power cord is unplugged.
NOTE
The chip cover cannot be attached with the base
in an inclined state.
(1) Position the unit at a right angle to the surface
(0-degree incline).
(2) Holding the chip cover's guide section open by
hand, push into the main unit.
(3) Insert the chip cover's catches into the main unit's
slots.
(4) When detaching, spread the catches of the chip
cover and draw them out from the main unit's
slots.
13. Switch Operation (Fig. 10)
<CJ160V>
The switch will activate when pulled and will
deactivate when released.
For continuous operation, pull the switch in all the
way and press the stopper.
To cancel continuous operation, once again pull
the switch in all the way until the stopper is freed,
and then release the switch.
<CJ160VA>
The switch will activate when slid forward and will
deactivate when released.
For continuous operation, push the switch
forward and press the front portion of the switch
down to lock it into position.
To unlock and shut off the switch, press the rear
portion of the switch.
14. How to use the LED light (Fig. 11)
When the switch is turned on, an LED lamp lights
to illuminate the end of the blade. This lamp goes
out when the switch is released.
CAUTION
Do not look directly into the light from the
LED lamp. Continuous and direct exposure
to the light from the LED lamp can injure your
eyes.
12
Chip cover's
catches
Guide section
Fig. 9
Stopper
〈 CJ160V 〉
〈 CJ160VA 〉
Fig. 10
LED light
Fig. 11
Slots
Switch Trigger
Switch
Publicidad
