Descargar Imprimir esta página

Ashley M8X222 Instrucciones De Montaje página 22

Publicidad

Idiomas disponibles

Idiomas disponibles

M8X222 / M8X232 / M8X242 / M8X252 / M8X272
PAIRING THE REMOTE CONTROL
You must pair the Bed Frame to a Remote Control before operation. Ensure the Bed Frame has been unplugged
for at least 10 seconds, then proceed as follows:
1. Plug the Bed Frame into the mains. This will automatically switch it to Pairing Mode for 30 minutes. In this
time, the Bed Frame will search for Remote Controls to be paired with.
2. During Pairing Mode, press and release any Button. This will pair the Remote Control to the Bed Frame.
UNPAIRING THE REMOTE CONTROL
1. Press and hold the Head UP and Foot DOWN Buttons for at least 10 seconds.
2.
The Remote Control will flash 3 times.
3. Test the Remote Control to check that it has been safely unpaired.
REFERENCE DRIVE
Before using the Bed Frame for the first time, you must perform a reference drive to check that the Bed Frame
is operating properly. When the drive is initiated, the lower section of the bed will move first, followed by the
upper section.
1. Press and hold the Head UP/DOWN, Foot UP/DOWN or Sleeping Position Button. The lower part of the
Bed Frame will begin the reference drive. It will reach a lower limit and then move up slightly. Do not release
the button.
2. Continuing to hold the button, wait for the upper part of the frame to complete the drive.
3. Release the button and use the Bed Frame according to the instructions.
If the drive is interrupted, pressing any movement button restarts downward movement.
MOVING THE BED FRAME UP AND DOWN
1. Press and hold the UP/DOWN Button for the Platform you wish to adjust.
2. Wait until the Bed Frame has reached the desired position.
3. Release the UP/DOWN Button.
The Bed Frame will move until the Button is released or the highest / lowest position is reached.
SAVING A MEMORY POSITION
There are two pre-saved Memory Positions: Anti-Snore (Position 1) and Zero Gravity (Position 2). Press the
Memory Position Buttons on the Remote Control to move to these positions. You can change saved Memory
Positions to new Memory Positions. To do this, proceed as follows:
1. Press and hold the UP/DOWN Button for the Platform you wish to adjust
2. Wait until the Bed Frame has reached the desired position
3. Release the UP/DOWN Button
4. Press and hold the Button for the new Memory Position for at least 3 seconds to save the
position. The Control Box will click twice to confirm.
5. Release the Memory Position Button.
ASHLEY®
All Rights Reserved.
Mar.2023
Page 22 Of 87

Publicidad

loading

Este manual también es adecuado para:

M8x232M8x242M8x252M8x272