Publicidad
Idiomas disponibles
Idiomas disponibles
M8X222 / M8X232 / M8X242 / M8X252 / M8X272
PERFORMING A FLAT POSITION RESET
To perform a Flat Position Reset:
1. Press the Sleeping Position Button for at least 10 seconds.
2.
The Control Box clicks twice to confirm the input.
3. Perform a Reference Drive with the Sleeping Position Button or any UP/DOWN Button
(see section "Reference Drive").
SYNC MODE (TXL ONLY)
IMPORTANT
Sync Mode allows you to control two Bed Frames with one Remote Control. If you only have one Bed
Frame continue reading at the next chapter.
Before configuring Sync Mode, please ensure:
▪ Both Bed Frames are standing next to each other
▪ The Bed Frames will not collide with each other when moving
▪ Each Bed Frame can be controlled using its own Remote Control
To activate Sync Mode:
1. Ensure both Bed Frames have been disconnected from the Power Outlet.
2. Connect the Control Boxes of the two Frames with the Sync Cable (M). This should be inserted into the port
marked "SYNC" on each Control Box.
K
3. Ensure the Cable is Routed so that it does not interfere with the movement of the Bed Frames.
4. Reconnect the Bed Frames to the Power Outlet.
▪ If the Bed Frames do not move together, disconnect from the Power and repeat the steps.
▪ To end Sync Mode, disconnect the Sync Cable.
MOVING THE BED FRAME UP AND DOWN IN SNYC MODE
When Sync Mode is activated, pressing the UP/DOWN Buttons on either of the Remote
Controls will move both Bed Frames simultaneously.
FIXING MISALIGNMENT
If two connected Bed Frames have different saved Memory Positions, pressing a Memory Position Button will
cause the Bed Frames to move to different positions. This is called Misalignment. In this case, you must move
both Bed Frames to their lowest position.
1. Press the Sleeping Position Button on one Remote Control
2. Wait for both Bed Frames to reach their lowest position
3. The Bed Frames are realigned. Continue using the Bed Frame as normal.
ASHLEY®
K
M
All Rights Reserved.
Mar.2023
Page 24 Of 87
Publicidad
