Publicidad
Idiomas disponibles
Idiomas disponibles
14
INSTALLATION
INSTRUCTIONS
Connecting
the
wafer
lines
1
Check the rubber seals on both sides of the hose.
- Insert a rubber seal into the threaded fittings on each
hose to prevent leaking.
Rubber seal
[__
_
Rubber seal
4
Connect the hoses to the water inlets tightly by hand and
then tighten another 2/3 turn with pliers.
- Connect the blue hose to the cold water inlet and the
red hose to the hot water inlet.
water
inlet
inlet
(To faucet)
Water
hose
(To water
inlet
on the
washing
machine)
Connect the water supply hoses to the HOT and COLD
water faucets tightly by hand and then tighten another
2/3 turn with pliers.
- Connect the blue hose to a cold water faucet and the
red hose to a hot water faucet.
-A WARNING
-,
* Do not overtighten.
Damage to the coupling can result.
3
After connecting the inlet hose to the water faucets, turn
on the water faucets to flush out foreign substances (dirt,
sand or sawdust) in the water lines. Let water drain into a
bucket, and check the water temperature.
5
A WARNING
damage the valves resulting in leaking and property
damage.
Check for leaks by turning on the faucets.
- If water leaks, check steps 1 to 4 again.
r@ NOTE
* For your safety, and for extended product life, use
only authorized components.
The manufacturer
is not
responsible for product malfunction or accidents caused
by the use of separately purchased, unauthorized parts.
* Use new hoses when you install the washing machine.
Do not reuse old hoses. Use only the inlet hoses
provided with the washer. LG does not recommend
the
use of aftermarket
hoses.
* Periodically check the hoses for cracks, leaks and wear,
and replace the hoses every 5 years.
* Do not stretch the water hoses intentionally,
and make
sure that they are not crushed by other objects.
* Water supply pressure must be between
14.5 psi and
116 psi (100N800 kPa). If the water supply pressure is
more than 116 psi, a pressure reducing valve must be
installed.
* To provide optimum washing performance the hot
water temperature
should be set at t20-t35°F
(48-57°C)
and the cold at 60°F (15°C).
Publicidad
