LG WM8500H A Serie Manual Del Propietário página 16

16 INSTALLATION INSTRUCTIONS
Leveling the washing machine
The washer tub of your new washing machine spins at very
high speeds. To minimize vibration, noise, and unwanted
movement, the floor must be perfectly level and solid.
1
Check that the washing machine is level.
- Check for levelness by rocking the top edges of the
washing machine or placing a level on the washing
machine. The slope beneath the washing machine must
not exceed 1° , and all four leveling feet must rest firmly
on the floor.
Level
4
Check again that the washing machine is level.
- Push or rock the top edges of the washing machine
gently to make sure that the washing machine does not
rock.
- If the washing machine rocks, repeat steps 1 to 3.
WARNING
o Using the washing machine without leveling may cause
it to malfunction, producing excess vibration and noise.
If you are installing the washing machine on the
optional pedestal, you must adjust the leveling feet
on the pedestal to level the washing machine. The
washing machine's leveling feet should be minimized
and the Iocknuts turned counterclockwise to secure
them.
" Use the leveling feet only when you level the washing
machine. If you raise the leveling feet unnecessarily, it
may cause abnormal vibration of the washing machine.
Turn the lower leveling feet clockwise to level the
washing machine.
- Turning the lower leveling feet clockwise raises the
washing machine.
Raise
Turn the Iocknuts counterclockwise and tighten them
when the washing machine is level.
Tighten all 4 lock
nuts securely using
the wrench.
If you install the washing machine on a slippery surface, it
may move because of excessive vibration. Incorrect leveling
may cause malfunction through noise and vibration. If this
occurs, lay the non-skid pads under the leveling feet and
adjust the level.
1
Clean the floor to attach the non-skid pads.
- Use a dry rag to remove foreign objects or moisture. If
moisture remains, the non-skid pads may slip.
2
Adjust the level after placing the washing machine in the
installation area.
3
Place the adhesive side of the non-skid pad on the floor.
- It is most effective to install the non-skid pads under the
front legs. If it is hard to place the pads under the front
legs, place them under the back legs.
This side up
Adhesw V
X
. "
_!_J-_._ J side A
Remove
backing
4
Check again that the washing machine is level.
- Push or rock the top edges of the washing machine
gently to make sure that the washing machine does not
rock. If the washing machine rocks, level the washing
machine again.