Descargar Imprimir esta página

Kärcher SC 1 Upright Manual Del Usuario página 12

Ocultar thumbs Ver también para SC 1 Upright:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
reservoir have been inserted correctly and there is
enough water in the water reservoir.
 Press the steam on/off switch by foot. The steam
stops in few seconds.
 Open the reservoir cover, and fill the water reservoir
with max. 0.2 l tap water directly at the device.
Illustration D
or
 Remove the water reservoir, open the reservoir cov-
er, and fill with max. 0.2 l tap water, see chapter Fill-
ing water.
Illustration E
Interrupting operation
ATTENTION
Material damage due to condensate/moisture
The floor covering can be damaged by moisture remain-
ing on the floor cleaning cloth or device after cleaning.
Remove the floor cleaning cloth and dry the device after
finishing the cleaning work.
Do not place or store the device on heat-sensitive sur-
faces.
ATTENTION
Damage to the material and the device
The floor covering and the device can be damaged by
consistently steam while the device stands still.
Switch off the device every time you leave.
Press the steam on/off switch by foot. The steam stops
in few seconds.
In order to save energy, we recommend that you switch
off the device for breaks in operation of longer than 20
minutes.
1. Press the steam on/off switch by foot. The steam
stops in few seconds.
2. Pull the mains plug out of the socket.
Illustration K
3. Park the device.
Illustration H
Switching off the device
1. Press the steam on/off switch by foot. The steam
stops in few seconds.
2. Pull the mains plug out of the socket.
Illustration K
3. To drain the water reservoir, see chapter Draining
the water reservoir.
Illustration L
Storing the device
1. To remove the floor cleaning cloth, see chapter How
to use the Accessories.
Illustration G
2. Remove the moisture from the device.
3. Wind the power cable around the lower and upper
cable hooks.
Illustration M
4. Store the device in a dry location that is protected
from frost.
Important application instructions
Cleaning the floor areas
We recommend sweeping the floor or vacuum cleaning
it before using the appliance. In this way the floor will be
cleared of dirt and loose particles before the wet clean-
ing.
12
The device is suitable for cleaning washable floor cov-
erings, e.g. stone floors, tiles and PVC floors, as well as
sealed wooden floors such as parquet and laminate.
ATTENTION
Damage due to steam effect
Heat and the effects of steam can lead to dam-
age.Check the heat resistance and steam effect on an
inconspicuous area using a minimal volume of steam
prior to use.
Do not remain the steam in the same position on the
sealed wooden floors for too long.
Note
Detergent residues or care emulsions on the surface to
be cleaned can cause streaks during steam cleaning,
but these disappear after repeated use.
CAUTION
Beware of burns to your feet
The floor head/floor cleaning cloth heats up during
steaming.
Hot water may drip out when pulling off the floor cloth.
Only operate or remove the floor head/floor cleaning
cloth with suitable footwear.
For fastening the floor cleaning cloth to the floor head,
please refer to chapter How to use the Accessories
How to use the Accessories
The floor cloth is suitable for cleaning stone floors, tiles
and PVC floors, and also sealed wooden floors such as
parquet and laminate.
Removing the floor cleaning cloth
Note
Please make sure the device is switched off before re-
moving the floor cleaning cloth.
1. Place one foot on the bottom corner of the floor
cleaning cloth and lift the floor head up.
Illustration G
Note
Initially, the floor cleaning cloth's hook and loop fastener
strip is very strong and cannot be removed from the
floor head easily. After the floor cleaning cloth has been
used several times and washed, it is easier to remove
from the floor head and it has reached the optimum ad-
hesion.
Care and service
Draining the water reservoir
ATTENTION
Device damage due to water putrefaction
If the device is not put into operation for more than 2
months, the water in the reservoir may putrefy.
Drain the water reservoir before breaks in operation.
1. Remove the water reservoir and open the reservoir
cover.
2. Drain the water reservoir.
Illustration L
Replacing the decalcification cartridge
ATTENTION
Device damage and shortened service life
Please replace the decalcification cartridge in 4 months
or a flow of approx. 15 l of water. If the decalcification
cartridge is not replaced in time, there is a risk of device
damage and the service life of the device may be short-
ened.
English
Floor cloth

Publicidad

loading

Este manual también es adecuado para:

Kst 1 upright