Sage Barista Express BES876 Guía Rápida página 18

ADJUSTING CONICAL BURRS
Some types of coffee may require a wider grind range to achieve an ideal extraction or brew.
A feature of your Barista Express Impress
upper burr. We recommend making only one adjustment at a time.
1 2
Unlock hopper Hold hopper over container & turn dial
to release beans into container
7 8
Remove wire Move adjustable
handle from both top burr, 1 number,
sides of the burr coarser or finer
14 15
Lock hopper Check your
extraction
RESET DEFAULT SETTINGS
Reset Auto Dose Time
Resetting the auto dose time is recommended
if there is a significant change to the grind size
or there is an accidental double dose into the
portafilter.
The machine must be on STANDBY mode.
• Press and hold 'Manual Dose' button and
'Filter' button for 3 seconds to reset grind time
to factory settings.
• The machine will confirm the reset when the
control panel lights for filter, grind mode and
dial will flash 3 times with beeping sounds.
• The machine will return to STANDBY mode.
Reset Extraction Time
The machine must be on STANDBY mode.
• Press and hold the 'Filter' and 1 CUP and
2 CUP buttons for 3 seconds.
18
is the ability to extend this range with an adjustable
™
3
Align hopper
into position
9 10
Align the number Insert wire handle
with the handle from both sides of
opening the burr
4
DOSE
Run grinder Remove hopper
until empty
11 12
Push upper burr Lock upper burr
firmly into position
• The machine will beep 3 times.
• The machine will then go into ready mode on
next power on.
ALERTS
No Hopper Warning
The filter lights flash between single and double
basket size, the hopper is not attached correctly.
Check the hopper and ensure the bean hopper
is inserted correctly and locked in place.
Low Coffee Beans Warning
The 'Dose' button and the 'Dose Level' lights will
flash two red LEDS and will sound 3 beeps. Add
coffee beans to the hopper.
Tamp Lever Not at Home Position
The machine beeps 3 times and pauses dose
cycle. Return the lever to the up or home
position and press Dose button to continue.
5 6
Remove
upper burr
13
Align hopper
into position