Sage Barista Express BES876 Guía Rápida página 19

Care & Cleaning
REPLACING THE WATER FILTER
IN THE WATER TANK
1 2
Set date 3 months Soak water filter
ahead for 5 mins
4 5
Place filter into Install filter in
filter holder water tank
The provided water filter helps reduce the risk
of scale build-up in and on many of the inner
functioning components. Replacing the water
filter every three months will reduce the need to
descale the machine. If you live in a hard water
area, it is recommended to change the water
filter more frequently.
WARNING
After regular use, hard water can cause mineral
build up in and on many of the inner functioning
components, reducing the brewing flow, brewing
temperature, power of the machine, and taste of
the espresso.
• Remove the filter from the plastic bag, and soak
in a cup of water for 5 minutes.
• Rinse the filter under cold running water for
5 seconds.
• Insert the filter into the filter holder.
• Set the date dial 3 months ahead.
• To install, push down the filter to lock into place.
NOTE
For replacement of water filters contact Sage
Customer Service Centre or visit our website at
www.sageappliances.com
3
H 0
2
5m
Rinse water filter
6
Insert & lock
water tank
CLEANING CYCLE
NOTE
This is a back-flushing cycle and separate from
descaling.
The CLEAN / DESCALE light
a cleaning cycle is required.
1. Insert the 1 CUP filter basket into the portafilter,
followed by the supplied cleaning disc, followed
by one cleaning tablet.
2. Lock the portafilter into the group head and
place a large container beneath the portafilter
spouts.
3. Ensure the water tank is filled with cold water
and the drip tray is empty.
4. Press the POWER button to switch the
machine off.
5. Press and hold 1 CUP , 2 CUP and the
POWER buttons for 3 seconds.
+
6. The cleaning cycle will commence and last
for approximately 5 minutes. During this time,
water will intermittently flush into the portafilter
to dissolve the cleaning tablet and flush back
into the group head.
NOTE
No water should come through the portafilter.
7. Remove the portafilter and ensure the tablet
has completely dissolved. If the tablet has not
dissolved; repeat from step 4 of the cleaning
cycle until the tablet is dissolved.
8. Once the tablet has completely dissolved,
remove the cleaning disc, reinsert the portafilter
and press the 2 CUP button to rinse the brew
head. It is recommended to place a container
under the portafilter spout to avoid water
splashing onto the machine. Once complete,
make sure to wipe off any splashes with a soft
dry cloth.
will flash when
+
3s
19
EN