Dreame VTE1 Manual De Usuario página 5

Product Overview
EN
Accessories
Charger Extension Hose
2-in-1 Charging &
Storage Mount
(Including screws ×2, wall plugs
×2, mounting template sticker )
Extension Rod
Note: The images in this manual are for illustrative purposes only. The actual product may
differ.
4
Crevice Nozzle 2-in-1 Brush Nozzle
Smart Multi-brush Bar Mini Electric Brush
Product Overview
Introduction of Display Screen
Note: If the vacuum is not working properly, the screen display will produce an error
message. Please refer to the troubleshooting section to find your solution.
Setting Language
Press and hold the button for 3 seconds to open the language list, then press the button
to scroll through the language to select the desired one. Press and hold the button
for 3 seconds to use the selected language.
Note: The display screen will return the main page if there is no operation for more than 15
seconds.
Switching Suction Level
Press the button to switch between three suction levels of eco, med/auto, and turbo.
The corresponding suction level will be highlighted on the display screen.
Auto Mode will be activated and "Auto" will appear on the display screen only when using
the smart multi-brush bar. The vacuum will then automatically switch the suction level
between the floor/tile and the carpet.
Note:
• Stop the vacuum at any time while cleaning. Then it will continue to use the last selected
suction level when started again.
• Connecting the smart multi-brush bar to the vacuum will activate the Auto Mode. In this
mode, the vacuum can automatically adjust its suction level depending on the surface
type.
Electronic Lock/Reset Filter
• Press briefly to enter/exit lock
• Press and hold for 1.5 seconds to
enter the filter reset interface
Lock Status
Suction Level Status
Switching Suction Level
• Press briefly to switch the suction
levels
5
EN