Dreame VTE1 Manual De Usuario página 8

How to Use
EN
Working Methods
There are two working methods for the vacuum, which can be selected based on your
needs.
Method 1: Discontinuous Cleaning Mode
Press and hold the switch of the vacuum to start working, and release it to stop
immediately.
Method 2: Continuous Cleaning Mode (Electronic Lock)
Click the electronic lock key to switch to Continuous Cleaning mode, and then briefly press
the on/off switch to make the vacuum in Continuous Cleaning mode.
Use the electronic lock to free your fingers and avoid finger fatigue caused by holding the
switch.
Continuous
Cleaning Mode
Note:
• In this mode, briefly press the on/off switch to suspend the operation or start again，
and the working mode of the vacuum will not change.
• Click the electronic lock again to quit the Continuous Cleaning mode.
10
How to Use
Using Different Accessories
Smart Multi-Brush Bar
For cleaning floors such as marble, tile,
and low pile carpet. When Auto Mode is
activated, the vacuum will automatically
adjust its suction level depending on the
surface type.
Note: The smart multi-brush bar can be
attached directly to the vacuum.
2-in-1 Brush Nozzle
For vacuuming curtains, keyboards,
ceilings, sofas, vehicle interiors, coffee
tables, etc.
Mini Electric Brush
For vacuuming dirt, pet hair, and other
stubborn debris from sofas, bedding, and
other fabric surfaces.
Note: It is not recommended to vacuum on
fragile surfaces, such as silk.
Crevice Nozzle
Suitable for vacuuming cracks, corners of
doors and windows, stairs, and other hard-
to-reach places.
EN
11