Publicidad
Idiomas disponibles
Idiomas disponibles
Important safety instructions for the user
i
Notes on the battery-operated radio-controlled drive unit
– Protect external roller blind / radio drive unit from knocks during trans-
portation, storage and installation.
– Use only the charger approved by MHZ!
– The rechargeable battery is shipped partially charged.
rior to first use, the battery must be fully charged takes c. 6 hours .
– In subsequent operation, the time required to charge the battery when
fully discharged is c. 3 hours.
In order to preserve the battery s charge capacity, it should be
recharged at least every 6 months.
– The red LED on the charger lights up when the charger is plugged in
and indicates that charging is in progress. The battery is fully charged as
soon as the green LED comes on.
– Battery operating duration is dependent on blind unit size, fabric weight
and outside temperature. With average use the charging cycle is 3-6
months.
Battery and radio drive are fitted as one unit inside the roller blind tube.
A defective battery can only be removed and disposed of together with
the drive unit.
– Remote control range in enclosed buildings: c. 20 m.
– The setting of the end positions is retained even when the battery has
discharged.
– Radio drive and control system components are not compatible with
other manufacturers products.
– No synchronous running when using group control.
– At temperatures below freezing point, it is possible that when operating
the roller blind the blind fabric will be slower starting to move.
– At temperatures below -10° Celsius the blind should not be used/
operated.
– A low battery level is signalled by the drive system with multiple beeps
every time the blind moves. The battery should be immediately re-
charged in order to ensure the the blind functions flawlessly.
– If the roller blind stops due to the battery level being too low, the
battery is not yet close to being fully discharged. It should, however, be
charged as soon as possible so that it does not become so.
- Solar panel (optional): In order for it to function perfectly it should be
exposed to direct sunlight and be cleaned at regular intervals (at least
twice a year) using a damp cloth (lukewarm water). Otherwise it may
become necessary during the darker months of the year to additionally
charge the battery using a charger.
i
Technical data
A tubular motor with an integrated rechargeable battery is fitted in fixed
fashion inside the fabric tube around which the external roller blind is
wound. If necessary, it can be replaced. To have this done the blind unit
must be sent to the manufacturer via the specialist retailer.
Motor:
12V DC / 1.1Nm / 1.0A / 12W
Battery:
Li-Ion / 2200mAh
Temperature range:
-10° to +75°Celsius
Note on charging the battery
Caution! Danger of falling from ladders!
If charging is being done in an elevated position, a secure ladder must
be used. Only use the ladder on an even and load-bearing surface. Pay
attention to the maximum load-bearing weight.
The ladder must not be leaned up against the product.
If the ladder is not properly set up or the load put on it is uneven, it can
fall over.
Edition 04.2022
Subject to technical changes I
Operating instructions
i
Charge battery
ger that the charging socket or cable may be damaged when fully or
partially closing the window sash.
– The battery should be charged with the window slightly open. De-
pending on window type, the window sash can, with the charging
socket completely closed, be shut for the duration of the charging
process. By carefully closing the window, please check whether the
charging cable can be damaged by doing this (risk of it getting
squashed).
Notes on disposal
This appliance falls under EC Directive 2002/96/EC on reduc-
ing the growing amount of electrical scrap, the aim of which
is for waste from electrical and electronic devices to be re-
duced and disposed of in an environmentally compatible way.
This appliance must not be disposed of as general waste. To ensure
that its materials are recycled or disposed of properly, take the ap-
pliance to a local authority waste collection point provided for this
purpose.
Thoughtless, uncontrolled disposal can cause illness and environmental
harm. By ensuring that your product is disposed of or recycled in a
responsible way you are contributing to the protection of the environ-
ment and the safeguarding of public health.
CE product labeling
MHZ Hachtel GmbH & Co. KG
Sindelfinger Stra e 21, D-70771 Leinfelden-Echterdingen, Germany
2019
LE-014
EN 13561: 2004+A1:2008
Solix external roller blind 46-1190 / 46-1191
Attachment to the exterior of buildings and
other structures.
Wind resistance* = Class 2
* Please note "Use in windy conditions"
Solix external roller blind
– Open charging socket. This
is located top right on the
inside of the Solix frame
fitted within the window
frame. To do this, the
window sash must be
completely opened.
ush charging cable s
plug firmly into the
charging socket. LED on
the charger lights up red.
– Close charging socket com-
pletely, making sure that
the cable comes cleanly out
of the opening.
Otherwise there is a dan-
35
DE
FR
NL
EN
ES
IT
Publicidad
